Air Plasma Cutting Machine

Air Plasma Cutting Machine:- The Plasma power pack shall be portable type and designed for operation with Air Cutting Torch shall be light-weight and made from non-breakable material. The cutting torch shall be provided with a quick assembly/removal coupling end. It shall be possible to drag the torch on the work piece at full output without damaging consumables and nozzle from the molten metal spray. The torch shall be provided with post-flow features for reducing the torch stresses. The torch shall be provided with a manually operated trigger for ignition. The power cable and hose to connect the torch with the power source and cables shall be shielded against accidental damage. Input Power Supply Current Output Rated Output Voltage Cutting Capacity Duty Cycle@40°C Max. Output Rated open circuit voltage (OCV) High Arc facility Type of Power Supply Cutting Speed Air Pressure LCD Display Power Factor Gas Supply Weight* Class of insulation and protection Technical Specification 230 V +-10% Single Phase AC 50 Hz 45 Amp. at 50% duty cycle 145 VDС Clean Cut-12 mm (for Stainless Steel) Clean Cut-20 mm (for Mild Steel) Severance-29 mm (for Mild Steel) Pierce-12 mm (for Stainless Steel) 50%@45 Amp.,200-230 Volt, Single Phase 100%@32 Amp.,200-230 Volt, Single Phase 275 VDС No high frequency unit in plasma cutting machine, contact start technology with spring The machine should be IGBT Inverter based with dual threshold pilot circuit for enhanced consumable. Minimum current at pilot arc stage, which is automatically ramped up to set value when work piece is sensed. Continuous pilot are technology for cutting of wire mesh & expended material. 250 mm/minute (for 12 mm Stainless steel) 5.9 Bar Cutting 4.1 Bar Max. Control gouging 3.8 Bar Marking Pressure setting should be automatic i. Air pressure adjustment and display ii. Mode-Cutting/gouging iii. Ampere adjustment and display iv. Error code display for easy mainten Should display minimum last 5 error codes Oil free Air Less than 20 Kg "H" and IP 23 Aoh Key features:- Cutting Air ON/OFF control should be automatic. Post Airflow after every cycle for cooling consumables after cutting. Pressure adjustment should be automatic depending on - Mode, Torch lead length, Process being used. Cut Technology: Drag cutting (Touch and Cut) without using spacer rings. Pneumatic and Electrical connections are made together through connector avoiding need of external connections allowing easy change over. Smart sense technology should automatically set correct air pressure based on torch length and operating mode. Wide voltage tolerance to improve performance on motor generators and in low-line conditions. Torch should be designed for high impact and heat-resistance. Low maintenance for maximum uptime. Low consumable life for lower cost and more uptime. High power efficiency lower energy consumption. Have boost conditioner circuit, which improves performance on low-line voltage, motor generators, and fluctuating input power. 2. Air Compressor:- A portable electrically driven compressor of sufficient capacity with accessories is required for the equipment. It should meet the uninterrupted air supply requirement for continuous cutting operation. It should be suitable to work on generator power. The air compressor shall be provided with suitable handles to enable one/two person(s) to carry it from one place to another.