Technical Specification of Combination Cutter with Spreader (Battery- Operated)

1 General 2 Working Pressure Specification i. The unit shall be safer for heavy duty performance during rescue and salvage operation. ii. It shall be meeting latest standards of NFPA 1936 or EN 13204 or BIS standards and certified by TUV Germany / FM USA /EIL Delhi. iii. It should be made of anticorrosive material with the provision of carrying handles for operating the combi tool in all directions for safe and easy operation. iv. The combi tool shall be powered by an optimized highperformance battery, superior blade design and perfect pulling effect. v. The combi tool shall have blade opening and the force application perfectly matched to the relevant working range. vi. Application perfectly matched to the relevant working range. i. The battery-operated combi tool should be driven by a selfcontained hydraulic power and control system operating should not be less than 650 bar working pressure. ii. The combi tool shall not need to be connected to an external hydraulic source. It shall have its own integral pump and drive system Minimum 450 mm. i. Minimum 80 Ton (784 KN). ii. Should be able to cut A-36 Hot Rolled steel round bar of minimum 40 mm. diameter Minimum 90 KN 3 Opening (spreading) Width 4 Minimum spreading force Minimum- 1400 KN. 5 Cutting force 6 Pulling force 7 Weight Battery excluding 8 Operating Temperature 9 Pump 10 Accessories to be Supplied 11 Blades Maximum 25 kg. Should comply with the requirement of operating temperature as per the provisions of NFPA 1936 or EN 13204 or BIS Standards if available The pump and drive system shall be energized by 5.0 Ah 25V LiIon battery or more. i. One set of chain with holders, ii. One set of spare blades, iii. Complete Tool kit for maintenance and repairs i. Anodized for corrosion resistance. ii. Should be coated with corrosion resistant coating for extra corrosion resistance. iii. Design certified by EN/NFPA/ BIS Standards (if available) for the desired level of performance 12 Battery Charger and Each tool shall be provided with Three (3) numbers rechargeable Li-Ion batteries (1 for tool and 2 as spares). ii. Battery must be having min 5 Ah, 25 V specifications. iii. Two (2) nos. battery chargers 230V/50Hz (1 working and stand-by / spare), 1 iv. One (1) adapter with cable for using power supply 230V/50Hz for the alternate operation of the eqpt. 13 Other requirements of battery 111. 14 15 Certification/ Accreditation Guarantee/ warranty/ Service support Training The battery once attached to the tool should make a compact unit and have reasonable protection against the external impact. ii. It may also have lock/unlock switch/latch as a safety precaution. The battery slot should be ergonomically designed so as not to obstruct the rescuer even in confined spaces. BIS Certificate (If available)/ EN: 13204/NFPA 1936 11 ii i. Warranty: 03 years and extended upto 05 years The bidder should be able to conduct the repairs of the tools post warranty period for minimum ten years at a place as specified in the bid wherein it will be clearly laid out the possible procedure for the repairs and maintenance. Bidder / OEM to provide an undertaking for the same. i. Two days base workshop level training to NDRF personnel in OEM/Firm premises/Location in India on full fledged running, testing, diagnostic, trouble shooting, maintenance, techniques for detection and calibration. ii. 01-day operator level training should be provided at user defined location 16 Carry Case 17 Manual literatures and Injection moulded plastic or Aluminum case with customized Body The following should be provided with the equipment: a. User Operation Manual/technical Manual, b. Detailed operators' instructions. c. Technical literature, d. Maintenance manual, Inspection standards be provided with the equipment